PVC lightstands can support flash units with DIY adapter

    As promised, here's how to mount a flash unit on your PVC light stand.

    Everybody is familiar with flash units, especially on-camera flash. Some people started out with the built-in flash, but the first major upgrade is going with a speed light on the hot shoe.

    But if you want to take your flash photography to the next level, you need to get the flash off the camera, allowing you to get better lighting angles than if it's attached to the top of your camera, or on a bracket to the side.

    We won't get into how to trigger the flash, as the DIY options involve some knowledge of electronics and there are options available such as wireless transmitters or using our camera's on-board flash as a "master" to trigger the "subordinate" flashes.

    But the question is how to set the flash up away from the camera. Most speed lights nowadays come with a small cold-shoe base you can attach to the bottom of the flash. This base lets you set it on a table or shelf, but that doesn't help much when there's nothing to sit it on.

    The flash makers recognize that, and these feet have a 1/4x20 hole in the bottom to attach it to a tripod. That's a good alternative, but suppose you need the tripod for a camera, or you don't have the room to set up one or more tripods (they do take up quite a bit of real estate)?

    PVC light stands, particularly the one I built based on Scott Eggelston's (The Frugal Filmmaker) plan, take up one square foot of floor space.

    Using Scott's plan for hacking a worklight, I got a set of four 3/4" PVC end caps to make four flash mounts. While Scott just put a bolt through the cap to attach to the work light, a flash is different, since it would also need to swivel and tilt.

    I found a set of fairly heavy duty ball heads on eBay (I had asked Scott if a ball head he had used in a different project would work for a speed light, but he told me to get something with a greater weight rating.) that could hold a DSLR with lens if needed.

    I attached the head to 1/4x20 bolt through the cap, giving me a mount that can slip over the 3/4" pipe on the lightstand.

    The ball head is fully adjustable and the flash stand attaches easily and securely to it.